Mastercook Dishwasher Manuel d'utilisateur Page 52

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 60
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 51
24
FREN
14 / IF OPERATING ABNORMALITIES OCCUR
SUMMARY OF THE FAULTS
BEFORE CALLING FOR SERVICE
Problem Possible
C
auses What to do?
The door falls heavily when
opened (integratable model)
- Door springs not tensioned
enough to compensate for the
weight of the panel.
- Tighten the two tensioning
screws accessible in the bot-
tom section above the front
feet.
The door does not stay horizontal
when open or returns too
quickly
(integratable model)
- Door springs tensioned too
much.
- No wooden panel.
- Loosen the two tensioning
screws accessible in the bot-
tom section above the front
feet.
- Fit a temporary wooden panel
on the appliance and adjust
the springs.
The door catches when closing - Appliance not stable
- Door not centred on the tub
- Adjust the feet.
- Re-centre by adjusting the
rear feet.
The upper basket does not stay
in the high position
- Poor manipulation (the basket
is being pulled upwards too
quickly)
- Act more progressively (see
instructions), one side and
then the other.
Small leak around or under the
appliance (move the appliance
to locate the leak)
- Leak from the tap.
- Leak from the appliance.
(Cf. table fault d07).
- Check that a seal is fitted and
retighten the nut.
- Close the water tap and call a
technician.
Small leak at the door
- Appliance not stable or not level
- Door not centred on the tub.
- Adjust the feet.
- Re-centre by adjusting the rear
feet.
for non-display models : light(s) flashing

d01: water intake fault (tap).
d07: overflow/leak protection fault


d02: draining fault. d08: sprinkler distribution fault.



d03: heating fault. d11: sprinkler distribution fault.


d04: temperature sensor fault.
d12: water level fault (siphoning
through drain tube)


d05: low pump flow fault. d13: overheating fault.


d06: high pump flow fault.
d14:
bad drain tube connection or
tap flow insufficient or filters dirty.

9h12h
3h
6h
9h12h
3h
6h
Tip:
If one of the above faults occurs and you need to call a repair man, remember to tell him
the message displayed (d01, d02..) as this information will help him.
Vue de la page 51
1 2 ... 47 48 49 50 51 52 53 54 55 56 57 58 59 60

Commentaires sur ces manuels

Pas de commentaire